SRC = led.c # MCU name #MCU = at90usb1287 MCU = atmega32u4 # Processor frequency. # This will define a symbol, F_CPU, in all source code files equal to the # processor frequency in Hz. You can then use this symbol in your source code to # calculate timings. Do NOT tack on a 'UL' at the end, this will be done # automatically to create a 32-bit value in your source code. # # This will be an integer division of F_USB below, as it is sourced by # F_USB after it has run through any CPU prescalers. Note that this value # does not *change* the processor frequency - it should merely be updated to # reflect the processor speed set externally so that the code can use accurate # software delays. F_CPU = 16000000 # # LUFA specific # # Target architecture (see library "Board Types" documentation). ARCH = AVR8 # Input clock frequency. # This will define a symbol, F_USB, in all source code files equal to the # input clock frequency (before any prescaling is performed) in Hz. This value may # differ from F_CPU if prescaling is used on the latter, and is required as the # raw input clock is fed directly to the PLL sections of the AVR for high speed # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' # at the end, this will be done automatically to create a 32-bit value in your # source code. # # If no clock division is performed on the input clock inside the AVR (via the # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. F_USB = $(F_CPU) # Interrupt driven control endpoint task(+60) OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT # Boot Section Size in *bytes* # Teensy halfKay 512 # Teensy++ halfKay 1024 # Atmel DFU loader 4096 # LUFA bootloader 4096 # USBaspLoader 2048 OPT_DEFS += -DBOOTLOADER_SIZE=4096 # Build Options # comment out to disable the options. # BOOTMAGIC_ENABLE ?= yes # Virtual DIP switch configuration(+1000) MOUSEKEY_ENABLE ?= no # Mouse keys(+4700) EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450) CONSOLE_ENABLE ?= yes # Console for debug(+400) COMMAND_ENABLE ?= yes # Commands for debug and configuration NKRO_ENABLE ?= yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work RGBLIGHT_ENABLE ?= yes # Enable keyboard underlight functionality (+4870) BACKLIGHT_ENABLE ?= yes # Enable keyboard backlight functionality (+1150) MIDI_ENABLE ?= no # MIDI controls AUDIO_ENABLE ?= no UNICODE_ENABLE ?= no # Unicode BLUETOOTH_ENABLE ?= no # Enable Bluetooth with the Adafruit EZ-Key HID #ifdef BACKLIGHT_ENABLE SRC := backlight.c $(SRC) #endif ifndef QUANTUM_DIR include ../../Makefile endif